Visit our Customer Experience Center for all of our latest demos Register Now
Color CMOS (1340 x 1020) HDR Image Sensor with PureCel®Plus Technology
  • SKU
    OX01F10-E48Y-1D-Z

OMNIVISION’s OX01F10 is a 1.3MP SoC, providing automotive designers with the industry’s best imaging performance across a wide range of challenging lighting conditions, along with the most compact form factor and lowest power consumption. In a single, 1/4″ optical format package, the OX01F10 integrates a 3.0 micron image sensor and an advanced image signal processor (ISP) with OMNIVISION’s PureCel®Plus technology for low noise, solving the automotive rear view camera (RVC) and surround view system (SVS) challenges of achieving a small form factor with excellent low-light performance, ultra-low power and reduced cost while improving reliability by using only one printed circuit board (PCB).

This SoC employs dual conversion gain (DCG) technology to achieve high dynamic range with only two captures, as opposed to three required by the competition, which minimizes motion artifacts while reducing power consumption and boosting low-light performance.

The OX01F10 power consumption is 30% lower than competitors and significantly reduces the temperature. It does not require a metal heat sink, allowing for the use of plastic camera module bodies to reduce costs. With its compact package size, it also enables smaller cameras that can fit in much tighter spaces. In addition, by integrating both the image sensor and ISP into a single chip, designers can save on both cost and space by eliminating the second PCB in typical two-chip implementations.

This SoC provides 1.3MP resolution and a 1340 x 1020 array size at 30 fps, offering ample resolution for calibration. It also enables output flexibility with both 2-lane MIPI and 10-bit DVP interfaces, and is AEC-Q100 Grade 2 certified.

OMNIVISION’s Automotive SoC Offers Rear and Surround View Cameras Industry’s Best Low-Light Performance, Lowest Power and Smallest Size

Support for image size:
– 1340 x 1020 and any cropped size

High dynamic range

High sensitivity

Dual conversion gain

ASIL-B safety feature

Image sensor process functions:
– AEC/AGC/AWB
– Lens correction
– Defective pixel correction
– HDR combination
– Tone mapping
– Automatic black level correction

Supported output formats:
– YUV
– RGB888
– BT656
– RAW

SPI master for loading settings

50/60 Hz flicker cancellation

SCCB for register programming

Programmable GPIOs

High speed serial data transfer with MIPI CSI-2 or DVP

External frame synchronization capability

Embedded temperature sensor

One-time programmable (OTP) memory

  • Spec
    OX01F10-E48Y-1D-Z
  • Analog / Digital
    Digital
  • Category
    1MP and Below
  • CFA (Chroma)
    Color
  • Frame Rate
    Full @ 30 fps
  • Image Area
    4080 x 3108 µm
  • Interface
    MIPI
  • Optical Format
    1/3.55" for 1340 x 1020 image size
  • Output Format
    BT656, RAW, RGB888, YUV
  • Package
    a-CSP™
  • Pixel Size
    3.0 µm
  • Resolution
    1.3MP
  • Shutter Type
    Rolling Shutter
  • Technology
    HDR, PureCel®Plus
  • Use Case
    Viewing Applications - E-mirrors, Viewing Applications - Rear View Camera
  • Operating Temperature
    -40°C to +125°C